Part number 1756-L905TS is a A SIL 2 safety controller with 5 MB standard memory, 5 MB safety memory, two gigabit Ethernet ports, 100 EtherNet/IP devices and 1,000 OPC UA nodes.
Item NO.:
1756-L905TSBrand/ Manufacturer:
PLCDimensions:
5590 5 MB SIL 2 Safety ControllerWeight:
5590 safety controllerCountry of Origin: :
5 MB standard / 5 MB safety; 1756 chassis mounting; 100 EtherNet/IP / 1,000 OPC UA nodesDescription:
Official model-specific data for 1756-L905TSConfirm the installed hardware, electrical design and approved engineering project before replacement.
Engineering note: Validate the L905TS identity, Series, firmware, safety partner and signature, chassis revision, 5 MB memory pair and complete node demand.
Installation planning
Confirm 1756-L905TS enclosure, chassis airflow, installed orientation and chassis-specific temperature limits before installation.
Storage and handling
Keep 1756-L905TS protected from impact, contamination, moisture and electrostatic discharge before installation.
Send the full model, Series, firmware, required quantity and destination before ordering.
The 1756-L905TS is a SIL 2 safety controller with 5 MB standard memory, 5 MB safety memory, two gigabit Ethernet ports, 100 EtherNet/IP devices and 1,000 OPC UA nodes.
Compatibility must be checked from the complete catalog number, installed chassis or I/O assembly, firmware, network, safety or motion configuration and engineering project.
Lifecycle assessment from the exact product record: The official manufacturer record used for this page identifies 1756-L905TS as Active. This status applies to the complete catalog number and must not be inferred from a neighboring model.
Regional orderability, available Series and firmware, lead time and successor options can vary. Confirm the current supply position for the requested quantity and destination.
Important: lifecycle status does not establish drop-in compatibility. Verify the installed chassis or I/O assembly, firmware, network, safety or motion functions and approved engineering project before replacement.
The following scenarios use the exact catalog capabilities shown on this page. Final suitability must be confirmed against the installed system and approved engineering project.
Use the documented 5 MB standard / 5 MB safety memory capacity together with the 100 EtherNet/IP / 1,000 OPC UA nodes network limit when reviewing project size and expansion margin.
Match 1756-L905TS, Series, firmware, 1756 chassis mounting, 2 × 1 Gb Ethernet ports and the approved project before replacement or commissioning.
Validate the L905TS identity, Series, firmware, safety partner and signature, chassis revision, 5 MB memory pair and complete node demand.
1756-L905TS provides 5 MB standard / 5 MB safety. Confirm compiled project usage, retained data and online-change margin before migration.
1756-L905TS is rated for 100 EtherNet/IP / 1,000 OPC UA nodes. Count configured devices and reserve capacity for diagnostics and future additions.
Confirm the intended 1756 chassis mounting, compatible power and terminal components, enclosure clearances, grounding, ventilation and applicable installation instructions.
No. Similar memory or housing does not prove equivalence. Check suffix, Series, firmware, ports, safety or motion functions, I/O limits and project configuration.
1756-L905TS is identified with 2 × 1 Gb Ethernet ports. Confirm port mode, addressing, ring or linear topology, switch settings and cable category for the actual project.
1756-L905TS uses a USB-C interface. Service work must follow the correct cable, software release, access-control and electrical-safety procedure.
Verify catalog number and Series, energize within the documented ratings, confirm status indicators, load the approved project, validate communications, then test I/O and machine functions under the site commissioning plan.
1756-L905TS is specified as Safety task supported; its safety classification is SIL 2 safety processor. Do not infer additional functions from a neighboring catalog number.
Provide the full catalog number, Series, firmware, quantity, destination, chassis or local I/O arrangement, network topology, machine application and photos of the installed nameplate.
The two PDFs below are hosted on dcsmodule.com and were prepared by Moore Automation from the exact manufacturer product record and applicable official publications. They are independent references, not manufacturer-issued manuals.
Article-specific identification, lifecycle context, application guidance and procurement checks for this exact catalog number.
OPEN SITE PDF →MOORE AUTOMATION PDFModel-specific specification matrix, installation and commissioning checks, plus an official-source trace for engineering review.
OPEN TECHNICAL DATA PDF →Ask for current product photos, the complete catalog label, Series, firmware, ports, terminals, packaging and current product condition. Verify that the supplied unit carries the exact 1756-L905TS catalog number.
| Specification | Official identification / verification note |
|---|---|
| Article number | 1756-L905TS |
| Controller family | 5590 safety controller |
| Memory | 5 MB standard / 5 MB safety |
| Safety function | SIL 2 safety processor |
| Installation format | 1756 chassis mounting |
| Motion capability | Safety task supported |
| Network capacity | 100 EtherNet/IP / 1,000 OPC UA nodes |
| Ethernet | 2 × 1 Gb Ethernet ports |
| Service interface | USB-C interface |
| Lifecycle | Active |
Send the full 1756-L905TS catalog number, required quantity and delivery country. Our team can check current availability and arrange nameplate photos, packaging images or live/recorded video verification where available.
Confirm the exact catalog number, available quantity, condition and estimated dispatch time.
Check the model, Series, firmware, ports, terminals and visible product condition before shipment.
Review the installed system, firmware, I/O, network and project requirements for this exact model.
Send the exact model, quantity and destination for quotation and availability checking.
The Moore Automation team was responsive, professional, and easy to work with. Every step of the quotation and ordering process was communicated clearly.
Tiffany provided patient and thoughtful support throughout the inquiry. Her prompt follow-up and clear answers made the purchasing process smooth and reassuring.
Tel : +86 18030235313
Whatsapp & Wechat : +86 18030235313
Email : [email protected]
1 Year Warranty
