Part number 5069-L320ERM is a A motion-capable controller with 2 MB user memory, support for 16 local I/O modules, 8 integrated-motion drive axes and up to 40 EtherNet/IP devices.
Item NO.:
5069-L320ERMBrand/ Manufacturer:
PLCDimensions:
5380 2 MB Motion ControllerWeight:
5380 motion controllerCountry of Origin: :
2 MB; 16 local I/O modules; 40 EtherNet/IP devicesDescription:
Official model-specific data for 5069-L320ERMConfirm the installed hardware, electrical design and approved engineering project before replacement.
Engineering note: Confirm the exact motion catalog number, 16-module local I/O limit, required axis count, Series, firmware and network architecture.
Installation planning
Confirm 5069-L320ERM enclosure, cabinet airflow, mounting arrangement and operating temperature before installation.
Storage and handling
Keep 5069-L320ERM protected from impact, contamination, moisture and electrostatic discharge before installation.
Send the full model, Series, firmware, required quantity and destination before ordering.
The 5069-L320ERM is a motion-capable controller with 2 MB user memory, support for 16 local I/O modules, 8 integrated-motion drive axes and up to 40 EtherNet/IP devices.
Compatibility must be checked from the complete catalog number, installed chassis or I/O assembly, firmware, network, safety or motion configuration and engineering project.
Lifecycle assessment from the exact product record: The official manufacturer record used for this page identifies 5069-L320ERM as Active. This status applies to the complete catalog number and must not be inferred from a neighboring model.
Regional orderability, available Series and firmware, lead time and successor options can vary. Confirm the current supply position for the requested quantity and destination.
Important: lifecycle status does not establish drop-in compatibility. Verify the installed chassis or I/O assembly, firmware, network, safety or motion functions and approved engineering project before replacement.
The following scenarios use the exact catalog capabilities shown on this page. Final suitability must be confirmed against the installed system and approved engineering project.
Use the documented 2 MB memory capacity together with the 40 EtherNet/IP devices network limit when reviewing project size and expansion margin.
Match 5069-L320ERM, Series, firmware, 16 local I/O modules, 2 × 1 Gb Ethernet ports and the approved project before replacement or commissioning.
Confirm the exact motion catalog number, 16-module local I/O limit, required axis count, Series, firmware and network architecture.
5069-L320ERM provides 2 MB. Confirm compiled project usage, retained data and online-change margin before migration.
5069-L320ERM is rated for 40 EtherNet/IP devices. Count configured devices and reserve capacity for diagnostics and future additions.
Confirm the intended 16 local I/O modules, compatible power and terminal components, enclosure clearances, grounding, ventilation and applicable installation instructions.
No. Similar memory or housing does not prove equivalence. Check suffix, Series, firmware, ports, safety or motion functions, I/O limits and project configuration.
5069-L320ERM is identified with 2 × 1 Gb Ethernet ports. Confirm port mode, addressing, ring or linear topology, switch settings and cable category for the actual project.
5069-L320ERM uses a USB programming interface. Service work must follow the correct cable, software release, access-control and electrical-safety procedure.
Verify catalog number and Series, energize within the documented ratings, confirm status indicators, load the approved project, validate communications, then test I/O and machine functions under the site commissioning plan.
5069-L320ERM is specified as Up to 8 position-looped drive axes; its safety classification is Not safety-rated. Do not infer additional functions from a neighboring catalog number.
Provide the full catalog number, Series, firmware, quantity, destination, chassis or local I/O arrangement, network topology, machine application and photos of the installed nameplate.
The two PDFs below are hosted on dcsmodule.com and were prepared by Moore Automation from the exact manufacturer product record and applicable official publications. They are independent references, not manufacturer-issued manuals.
Article-specific identification, lifecycle context, application guidance and procurement checks for this exact catalog number.
OPEN SITE PDF →MOORE AUTOMATION PDFModel-specific specification matrix, installation and commissioning checks, plus an official-source trace for engineering review.
OPEN TECHNICAL DATA PDF →Ask for current product photos, the complete catalog label, Series, firmware, ports, terminals, packaging and current product condition. Verify that the supplied unit carries the exact 5069-L320ERM catalog number.
| Specification | Official identification / verification note |
|---|---|
| Article number | 5069-L320ERM |
| Controller family | 5380 motion controller |
| Memory | 2 MB |
| Safety function | Not safety-rated |
| Installation format | 16 local I/O modules |
| Motion capability | Up to 8 position-looped drive axes |
| Network capacity | 40 EtherNet/IP devices |
| Ethernet | 2 × 1 Gb Ethernet ports |
| Service interface | USB programming interface |
| Lifecycle | Active |
Send the full 5069-L320ERM catalog number, required quantity and delivery country. Our team can check current availability and arrange nameplate photos, packaging images or live/recorded video verification where available.
Confirm the exact catalog number, available quantity, condition and estimated dispatch time.
Check the model, Series, firmware, ports, terminals and visible product condition before shipment.
Review the installed system, firmware, I/O, network and project requirements for this exact model.
Send the exact model, quantity and destination for quotation and availability checking.
The Moore Automation team was responsive, professional, and easy to work with. Every step of the quotation and ordering process was communicated clearly.
Tiffany provided patient and thoughtful support throughout the inquiry. Her prompt follow-up and clear answers made the purchasing process smooth and reassuring.
Tel : +86 18030235313
Whatsapp & Wechat : +86 18030235313
Email : [email protected]
1 Year Warranty
