Part number 5069-L330ERMS2 is a A SIL 2/PLd safety and motion controller with 3 MB standard memory, 1.5 MB safety memory, 31 local I/O modules, 16 axes and 60 EtherNet/IP devices.
Item NO.:
5069-L330ERMS2Brand/ Manufacturer:
PLCDimensions:
5380 SIL 2 3 MB Motion Safety ControllerWeight:
5380 safety motion controllerCountry of Origin: :
3 MB standard / 1.5 MB safety; 31 local I/O modules; 60 EtherNet/IP devicesDescription:
Official model-specific data for 5069-L330ERMS2Confirm the installed hardware, electrical design and approved engineering project before replacement.
Engineering note: Check the complete ERMS2 identity, safety partner, Series, firmware, safety signature, 31-module I/O plan, 16-axis demand and network loading.
Installation planning
Confirm 5069-L330ERMS2 enclosure, cabinet airflow, mounting arrangement and operating temperature before installation.
Storage and handling
Keep 5069-L330ERMS2 protected from impact, contamination, moisture and electrostatic discharge before installation.
Send the full model, Series, firmware, required quantity and destination before ordering.
The 5069-L330ERMS2 is a SIL 2/PLd safety and motion controller with 3 MB standard memory, 1.5 MB safety memory, 31 local I/O modules, 16 axes and 60 EtherNet/IP devices.
Compatibility must be checked from the complete catalog number, installed chassis or I/O assembly, firmware, network, safety or motion configuration and engineering project.
Lifecycle assessment from the exact product record: The official manufacturer record used for this page identifies 5069-L330ERMS2 as Active. This status applies to the complete catalog number and must not be inferred from a neighboring model.
Regional orderability, available Series and firmware, lead time and successor options can vary. Confirm the current supply position for the requested quantity and destination.
Important: lifecycle status does not establish drop-in compatibility. Verify the installed chassis or I/O assembly, firmware, network, safety or motion functions and approved engineering project before replacement.
The following scenarios use the exact catalog capabilities shown on this page. Final suitability must be confirmed against the installed system and approved engineering project.
Use the documented 3 MB standard / 1.5 MB safety memory capacity together with the 60 EtherNet/IP devices network limit when reviewing project size and expansion margin.
Match 5069-L330ERMS2, Series, firmware, 31 local I/O modules, 2 × 1 Gb Ethernet ports and the approved project before replacement or commissioning.
Check the complete ERMS2 identity, safety partner, Series, firmware, safety signature, 31-module I/O plan, 16-axis demand and network loading.
5069-L330ERMS2 provides 3 MB standard / 1.5 MB safety. Confirm compiled project usage, retained data and online-change margin before migration.
5069-L330ERMS2 is rated for 60 EtherNet/IP devices. Count configured devices and reserve capacity for diagnostics and future additions.
Confirm the intended 31 local I/O modules, compatible power and terminal components, enclosure clearances, grounding, ventilation and applicable installation instructions.
No. Similar memory or housing does not prove equivalence. Check suffix, Series, firmware, ports, safety or motion functions, I/O limits and project configuration.
5069-L330ERMS2 is identified with 2 × 1 Gb Ethernet ports. Confirm port mode, addressing, ring or linear topology, switch settings and cable category for the actual project.
5069-L330ERMS2 uses a USB programming interface. Service work must follow the correct cable, software release, access-control and electrical-safety procedure.
Verify catalog number and Series, energize within the documented ratings, confirm status indicators, load the approved project, validate communications, then test I/O and machine functions under the site commissioning plan.
5069-L330ERMS2 is specified as Up to 16 position-looped drive axes; its safety classification is SIL 2 / PLd. Do not infer additional functions from a neighboring catalog number.
Provide the full catalog number, Series, firmware, quantity, destination, chassis or local I/O arrangement, network topology, machine application and photos of the installed nameplate.
The two PDFs below are hosted on dcsmodule.com and were prepared by Moore Automation from the exact manufacturer product record and applicable official publications. They are independent references, not manufacturer-issued manuals.
Article-specific identification, lifecycle context, application guidance and procurement checks for this exact catalog number.
OPEN SITE PDF →MOORE AUTOMATION PDFModel-specific specification matrix, installation and commissioning checks, plus an official-source trace for engineering review.
OPEN TECHNICAL DATA PDF →Ask for current product photos, the complete catalog label, Series, firmware, ports, terminals, packaging and current product condition. Verify that the supplied unit carries the exact 5069-L330ERMS2 catalog number.
| Specification | Official identification / verification note |
|---|---|
| Article number | 5069-L330ERMS2 |
| Controller family | 5380 safety motion controller |
| Memory | 3 MB standard / 1.5 MB safety |
| Safety function | SIL 2 / PLd |
| Installation format | 31 local I/O modules |
| Motion capability | Up to 16 position-looped drive axes |
| Network capacity | 60 EtherNet/IP devices |
| Ethernet | 2 × 1 Gb Ethernet ports |
| Service interface | USB programming interface |
| Lifecycle | Active |
Send the full 5069-L330ERMS2 catalog number, required quantity and delivery country. Our team can check current availability and arrange nameplate photos, packaging images or live/recorded video verification where available.
Confirm the exact catalog number, available quantity, condition and estimated dispatch time.
Check the model, Series, firmware, ports, terminals and visible product condition before shipment.
Review the installed system, firmware, I/O, network and project requirements for this exact model.
Send the exact model, quantity and destination for quotation and availability checking.
The Moore Automation team was responsive, professional, and easy to work with. Every step of the quotation and ordering process was communicated clearly.
Tiffany provided patient and thoughtful support throughout the inquiry. Her prompt follow-up and clear answers made the purchasing process smooth and reassuring.
Tel : +86 18030235313
Whatsapp & Wechat : +86 18030235313
Email : [email protected]
1 Year Warranty
